Marlin Firearms Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
I have just purchased an XT22MR. I cleaned the gun as directed and then took it out to test fire it. I found that the gun had no issues so far other than it would not extract the fired cases when I was using the 4 round magazine. There were no issues with unfired rounds extracting when the 4 round magazine was in place and no issues at all when I used the 7 round magazine. Has anyone else experienced this? I would think it was the extractor if it happened with both mags.
 

·
Registered
Joined
·
5 Posts
Discussion Starter · #3 ·
Thanks for the reply. I was using Remington 33 grain accu-tip. When I used the 4 shot mag, the case stayed completely in the chamber. If I dropped the mag and cycled the bolt, it would then extract and eject. With the 7 round mag it worked without any issues to extract and eject. It will extract and eject unfired rounds from the 4 shot mag.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top