Marlin Firearms Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
933 Posts
Discussion Starter · #1 ·
How difficult would switching forends on a 1894CB 357 with another of the same. Removing the old ones cause damage to the forends? Do I have to sand or cut them so they match well? How much skill factor is involved?

Matt
 

·
Registered
Joined
·
165 Posts
As long as both forends are for a cowboy model and they are finished factory marlin forends you should have no problem…..If you can use a flathead screwdriver and have about 10 minutes to spare you should be good to go. You just need to remove the 2 screws on the forend cap and the one holding the magazine tube to the barrel.
 

·
Registered
Joined
·
933 Posts
Discussion Starter · #3 ·
Thanks Cody

Matt

I tell you how it goes.
 

·
Registered
Joined
·
429 Posts
Will it be as easy to switch a fore end of a Zane Grey? I am looking for a laminated set to switch out. I am picking up a like new ZG and don't want to jack up the stock & fore end hunting. Does anyone know witch ones I should buy. I was going to order the 336 BL set and just make some mods to make them fit.
 
1 - 4 of 4 Posts
Top