Marlin Firearms Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
I’m putting a rifle basix trigger on an 880 sq. Installed trigger, everything went smoothly. When I replace the bolt to check that everything is working properly, the sear doesn’t align properly. I have about an eighth of an inch before sear will engage. Has anyone had this problem and if so please reply. Thanks
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top