[eli_harper13]

Any one have any suggestions on removing the finger lever plunger to change out the spring? The pin for it is so small my smallest punch is too big and I cant find any thing that small that is strong enough to take a strike from a hammer. Any help would be greatly appreciated!

 

[ramcat]

I just did my first lever swap (from stock to a Ranger Point Precision medium loop). Their directions are perfect, and I had no issues. I believe it takes a 1/16" punch. I was a little nervous before starting, but honestly it couldn't have been easier. Make sure to leave the punch "in" while you capture the plunger! Good luck!

 

[SIRJ]

If I’m not mistaken the 1/16” punch is what I use.

 

[444nut]

Take the point off a small naiL & use the nail if do not have a punch that will fit.

 

[eli_harper13]

Thanks for the replies guys! My 1/16 did fit. The problem was that the plunger must be pushed out from right to left, not left to right. I was trying left to right as that is what I am use to from changing sights.