Marlin Firearms Forum banner

61 - 64 of 64 Posts

·
Registered
Joined
·
3,265 Posts
I was thinking of some repurposed LITE BRITE pegs for the safety indicators.
When I put something away for safe keeping I find the best way to locate it is to buy a replacement.
Another fine project.
 

·
Registered
Joined
·
3,072 Posts
Discussion Starter #62
Got the Sling Mounts prepped and blued and installed today. On the agenda for in the a.m. is to deduce the best placement position for the RED / GREEN Safety Indicators and the correct sized bit to drill the holes for them to reside in.

This may turn out to be a nice looking little "Piece of Junk" ...

Will post a couple of pictures when it gets finished.
 

·
Registered
Joined
·
3,072 Posts
Discussion Starter #63 (Edited)
Frankengun .... Dun ... Sling Swivels and Safety Indicators in place. The Sling Swivels were in pretty rough shape. Rust pitted pretty bad and the screws were slot mangled. Cleaned and repaired the set and then blued them.

824497


824498


824499


824500


Installed the spare set of Safety Indicators.

* Note here ... screwed this up. Did not remember to orient the "F" and "S" lettering on the buttons. Looks really bad and amateurish but the epoxy prevents fixing it without destroying the buttons getting them out.

824494


824495


824496


I have attempted to save a NON-GUN ... An exercise in "Why did I do this, Really ?". No good answer to that ...
 
61 - 64 of 64 Posts
Top