Marlin Firearms Forum banner

Marlin 338mx Stock

828 views 6 replies 6 participants last post by  Cowboy23* 
#1 ·
I just picked up a 338mx and the only flaw is a crack in the stock. Does anyone know if a 336 stock will fit the 338? If not, does anyone know where I might find a 338mx Stock?
 
#7 ·
Yes---336 pistol grip style is the same. You may have to transfer over the plastic grip cap and or Marlin bullseye and blend them into the stock and then refinish.
What about repairing the crack ?? There are methods you can use depending on how it cracked where you cannot even tell it was repaired.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top