Marlin Firearms Forum banner
1 - 1 of 1 Posts

8 Posts
Discussion Starter · #1 ·
Renewing a JM 336 I recently picked up, rifle had a poorly fitted shotgun pad on it. Have long arms, need additional length of pull, so went with the grind to fit 1" Pachmayr Deaccelerator pad, which was a mistake. By the time I had it ground to close tolerances with the stock, the rubber was giving way to the metal liner underneath.

So...recommendations for a 3/4" to 1" rubber stock pad that will fit with no or minimal tweaking?

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.