Marlin Firearms Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
Renewing a JM 336 I recently picked up, rifle had a poorly fitted shotgun pad on it. Have long arms, need additional length of pull, so went with the grind to fit 1" Pachmayr Deaccelerator pad, which was a mistake. By the time I had it ground to close tolerances with the stock, the rubber was giving way to the metal liner underneath.


So...recommendations for a 3/4" to 1" rubber stock pad that will fit with no or minimal tweaking?

thanks!
 

·
Premium Member
Joined
·
25,508 Posts
I strongly reccomend theSims Limbsaver AirTech recoil pad.
The one you need is product #232391on Cabela's website.
No grind to fit...if your factory pad is already off,
half the job is done.

Another one I really like is the precision fit by Limbsaver
and it's product #10102 (mfr's #).
 

·
Registered
Joined
·
20 Posts
I strongly reccomend theSims Limbsaver AirTech recoil pad.
The one you need is product #232391on Cabela's website.
No grind to fit...if your factory pad is already off,
half the job is done.

Another one I really like is the precision fit by Limbsaver
and it's product #10102 (mfr's #).
I love the Limbsavers- have them on all of my shotguns- but the 10102 absolutely will NOT fit my new 336... something that I'm not very happy about.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top