Marlin Firearms Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
22 Posts
Discussion Starter · #1 ·
Does anyone know what the size and thread per inch is for the Thumb Lever on a Marlin 27? This is the take down lever on the right side of the receiver.

Thanks in advacne

Pat
 

·
Registered
Joined
·
71 Posts
Ill go measure it in a few minutes, it looks like a #12-24. i went to the garage and the ol florescent lights are cold and not working very well so I did not come up with a definite size other than it's most likely an odd ball @ .192 with about 32 TPI. Ill get my better thread pitch gauge from work and some better light in the next day or so.
 

·
Registered
Joined
·
71 Posts
I'm going to call it at a 10-36. That is the only one that makes sense. It is the same thread as the other side that the thumb wheel screws onto which is the hammer pivot stud/axle.
 

·
Registered
Joined
·
22 Posts
Discussion Starter · #4 ·
Thanks Marvin, now to find a 10-36 screw that I can cut and make into the screw for the Thumb Lever.

Thanks again

Pat
 
1 - 4 of 4 Posts
Top