Marlin Firearms Forum banner

1 - 3 of 3 Posts

·
Premium Member
All kinds. Enamored of their mechanisms!
Joined
·
11,362 Posts
Discussion Starter #1
Like the title says. I checked the stickys, and a few other references with no joy. Is there a standard? Thank you, AC
 

·
Registered
Joined
·
8,429 Posts
Thats about standard, I have seen them at 100 depending on the application. It all depends on the sight being used. Never assume the sight going to be installed is "standard". Measure it and then cut accordingly the depth.

Least thats been my hard earned experience over the years.

"Never presume anything" is usually a good rule to live by when drilling holes, or cutting on any aspect of a gun.
 
  • Like
Reactions: nstoolman1
1 - 3 of 3 Posts
Top