Marlin Firearms Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
249 Posts
Discussion Starter · #1 ·
Have been casting on an electric burner for a good while. Building a new casting area and want to try propane for the heat source. I have cooked a fair bit with propane, but have no experience with any of the single burner cast iron or steel free standing units.

Any recommendations as to which brand and btu requirements would be very much appreciated. Between my cast iron pot and about 25 lbs of alloy would be the weight requirement that it would need to support in a stable fashion. Also, would want a unit that has a good quality adjusting valve. Thanks, I will check back this evening. Thank You, Again.

Smoke Ratchet
 

·
Registered
Joined
·
20,660 Posts
enjoy
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top