Marlin Firearms Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
186 Posts
Discussion Starter · #1 ·
It's broken and I'm :( . Decided to swab the bore today before heading to the range and noticed excessive rattling in the bolt. Closer examination reveals broken spring, gizmo thingy at the rear of bolt where hammer hits. Question, is this one of those any dude can fixit yourself problems or do I call in professional backup? Question ,do I go with standard factory replacement or is there a better aftermarket alternative?
If this is an any dude project could someone point me to the how page. I used to have this saved but lost it in the last great internet spyware battle :evil: Any help would be greatly appreciated.Thankyou
Stumpyz66
 

·
Registered
Joined
·
210 Posts
It is a simple repair you can do yourself. Both the front and rear firing pins are held in with a roll pins. Just drive out the roll pin and remove the firing pin.
 

·
Registered
Joined
·
153 Posts
Stumpy,
I'd certainly call Marlin and see if they will send you a replacement under warranty.
Regards,
Rich
 
1 - 4 of 4 Posts
Top