Marlin Firearms Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
1,254 Posts
Discussion Starter · #1 ·
I just did the used gun fix on my .44. All except bend the carrier as I wasn't quite ready to be heatin and bendin.She seems cycle fine so far.
My questin is should I go ahead and bevel the cam on my .357?
She is still very tight in action as I think it was used little prior to me.
thanks
cw
 

·
Registered
Joined
·
1,254 Posts
Discussion Starter · #2 ·
Yes stupid do it.done.
No grove started.
feel bet ttt tt tt er.
cw
 

·
Registered
Joined
·
25,048 Posts
Ok I'm lost .. did you or didn't you???
 

·
Registered
Joined
·
1,254 Posts
Discussion Starter · #4 ·
I did!
I bought the gun from pawn which usually means they are well used and slick(notch cut too). But this one(.357) was not and the carrier had yet to develop a notch but you could see it wanting to form in two places.
The .44 locked up after hog hunting during fun shoot. Better then!.
cw
 
1 - 4 of 4 Posts
Top