Marlin Firearms Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter · #1 ·
Hello all.
I have a 80 DL that I took the extractors out of to clean some gunk out from behind. When the pins came out I did not notice the small notch on one end. I am not sure which way they go back in. It is the old style bolt with two extractors . Also if someone knows what years they used the bolt that has a sharp bend down then bends out right at the end it would sure be helpful to date the rifle.
Thanks To All

bvisteve
 

·
Registered
Joined
·
7 Posts
Did you ever determine how the pins went back in? I have a 80 DL that I just bought and it has one extractor that fell out when I had it on the range with my son. I found new extractors, pins and springs at Numrich. I noticed the notch on the pin as well and can't seem to locate information as to what the correct positioning is or if it makes a difference. I was pleasantly surprised though that the rifle cycled just fine with only one extractor. I believe my son has found a new love.

Thanks,
Craig
 
1 - 2 of 2 Posts
Top