I need a side scope mount for my Marlin Model 100 .22 Single Shot

[Keith_A]

Hi,

I'm new to the site.  My 9 year old daughter wants to learn to shoot.  I have a Marlin Model 100 single shot .22 that I want to mount a scope on.  The left side of the receiver has 4 drilled and tapped holes.  Where can I buy a scope mount that will fit?

I would really appreciate any help.

Thanks in advance.

[mudpuppy]

Welcome to MO,lots of folks here like to help a youngster get started.
Sounds like an old N-type Weaver 3/4 base,they'r on Ebay a lot.Finding one with the right hole pattern shouldn't be too hard.
  Post the distance between the holes here,Somebody might have one

[swany]

N2 mount is low not able to use iron sights. I would find one of these, they usually are 3/4 inch mounts and you will have to find a 3/4 scope the Weaver V22 is 3/4

N3 mount is high able to see your iron sights.

If you have the room on top you can get a mount that is round on the bottom and JB Weld it to the receiver easily removed later with heat if wanted. I have done this on several older .22s you may have to cut out part of the mount or use a two piece.

[mar39d]

I have a N2 Weaver Scope mount with screws.  $20.00 shipped if it would work for you.

[Keith_A]

mar39d,

Thanks for the reply.  Can you post a picture of the N2 mount.  I'd like to see it to determine if it might fit.

Thanks again

[mar39d]

I don't have any way to post a picture but if you send me your address I will send the mount to you. If it works, you can send the payment, if not, send it back. I have a Tom Mix 100 and it looks like it would fit on it.
Garry
gkjelden@msn.com